Wall Mounting - Camille Bauer SINEAX DME 406 Betriebsanleitung

6. Mounting
The SINEAX DME 406 can be mounted either on a top-hat rail
or directly onto a wall or mounting surface.
Note "Environmental conditions" in Section
"5. Technical data" when determining the place
of installation!
6.1 Mounting on top-hat rails
Simply clip the device onto the top-hat rail (EN 50 022) (see
Fig. 5).
Fig. 5. Mounting on top-hat rail 35 × 15 or 35 × 7.5 mm.

6.2 Wall mounting

While pressing the latch (4) in the base of the device (Fig. 5,
left) pull out the isolating amplifier securing brackets (1). To
return the brackets to their original positions, the latch (5) in
the base of the device has to be depressed before applying
pressure to the securing brackets (1) (see Fig. 5, right).
36
(1)
(2)
(3)
(2)
(4)
(1)
Fig. 6. Rear of device. (4) Latch for pulling the screw hole
(1) Screw hole brackets
(2) Top-hat rail clips (5) Latch for pushing the screw hole
(3) Rubber buffers
Drill 2 holes in the wall or panel as shown in the drilling pattern
(Fig. 7). Now secure the power pack to the wall or panel using
two 4 mm diameter screws.
Fig. 7. Drilling plan.
(1)
(5)
(1)
brackets out
brackets in.