Electrical Connection; Installation Instructions; Technical Data - HANSGROHE AXOR Starck Gebrauchsanleitung, Montageanleitung


Safety Notes
Intended Use
 This product is designed for use into dry areas of the
bathroom (Zone 3) only.
 The mains voltage of 100 - 240 V AC 50 - 60 Hz
must be supplied via a shutoff device (switch) as
well as a ground fault protector (RCD / FI) with a
measured differential current of ≤ 30 mA.
 A different or excessive use is considered non-
intended. The user/operator bears the sole risk.
The intended use includes the adherence to the
operating instructions and the observance of the
inspection and maintenance guidelines.
 The manufacturer/seller of this light does not assume
any responsibility for injuries or damage that may be
caused by improper installation or non-intended use.

Electrical installation
Electrician
 Installation and tests are to be performed by
an approved electrician, taking VDE 0100, Part
701 into account. It's a Legal Requirement for the
Installation and wiring to conform to current IEE
Electrical and Building regulations.

Electrical connection

 Voltage supply:100 - 240 V/N/PE/50 - 60Hz
Residual current protection system
 The circuit must be protected via a ground fault
protector (RCD / FI) with a measured differential
current of ≤ 30 mA.
 The proper function of this protective device must be
checked at regular intervals.
6
English

Installation Instructions

• Any work may only be carried out in a de-energized
state. Here, the voltage supply must be safely sepa-
rated via the main switch or mains plugs.
• Only standardized materials may be used for the
installation.
• All components must remain accessible.
• The ambient temperature must not exceed 40 ºC.
• During operation this lamp will get hot. A minimum
distance of 50cm should be maintained, away from
inflammable items.
Consistency of installation surface
Please also make sure that the installation surface is
even. If there are deep ridges or offset tiles, it is neces-
sary to even out this unevenness using silicone.

Technical Data

Nominal voltage:
Power:
Protection class:
Serial number:
Dimensions:
weight:
Assembly see page 60
240 V / 50 - 60 Hz
max. 40 W
IP 20
40856000 (see typeplate)
see page 61
785 g