Swivel Function; Thermal Cut-Out; Safety Switch - Silvercrest SHLF 2000 A1 Bedienungsanleitung

RP53439 HL mit FB LB3 Seite 9 Dienstag, 13. Juli 2010 3:05 15
The selected required temperature is shown
in the display 10.
The room temperature is measured by the
temperature sensor 7.
The heater switches off as soon as the room
reaches the required temperature. The fan
continues to run. If the room temperature
falls below the required temperature, the
heater switches on again automatically.
5.6 Setting the operating time
The appliance has a timer with which you
can set the required operating time. The
appliance switches off automatically once
the operating time has expired.
1. Press the "H" button 16 or 25 to set the
hours.
2. Press the "M" button 15 or 24 to set the
minutes.
Note: If you press and hold the buttons, the
values will continue to run until you release
the button again.
The selected operating time is shown in the
display 10.

5.7 Swivel function

The appliance has a swivel function.
This causes the appliance to swivel to and
fro, distributing the exiting air more evenly
through the room:
1. To switch the swivel function on, press
the swivel function button 17 or 21.
2. To switch the swivel function off, press
the swivel function button 17 or 21
again.
SHLF 2000 A1

5.8 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches off
automatically:
1. Switch the mains switch 8 to 0 to switch
off the appliance.
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly,
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.

5.9 Safety switch

The appliance is protected
accidental damage by a safety switch.
The safety switch is
located on the bottom
of the appliance and
switches the
appliance off
immediately should it
fall over:
1. Return the appliance to an upright
position.
2. Select the required function again (see
"5.1 Displays" on page 8).
have the
against
9