Ugolini Giant 2 Gebrauchsanweisung Seite 16

GIANT 2
figure 8
3 Slide the outer spiral out (see figure 9) and then the inside
auger (see figure 10).
figure 9
figure 10
4 Remove the bowl gasket from its seat (see figure 11).
figure 11
5 Remove the faucet assembly sliding the pin and pulling up
the handle. (see figure 12).
6 Slide the drip tray out and empty it.
7. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1 Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2 Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated com-
ponents of the unit. Electrical shock or damage to the
machine may result.
16
figure 12