Operation; Switching On/Off - Würth EWS 8-125 LIGHT Originalbetriebsanleitung

Attaching grinding wheel
WARNING !
Risk of severe injuries.
Pull the mains plug out of the plug
¾
socket before all tooling operations.
The machine must be switched off
¾
and at a standstill.
Locking spindle
▸
Press in spindle locking knob [12] and turn the
spindle by hand until the spindle locking knob
audibly engages.
Fitting abrasive wheel or disc
▸
Push supporting flange [10] onto the spindle.
It is fitted correctly when it cannot be turned on
3
the spindle.
▸
Push abrasive wheel [7] onto the supporting
flange [10].
• The grinding wheel must rest uniformly on the
supporting flange.
• The sheet metal flange of cut-off wheels must rest
on the supporting flange.
Risk of severe injuries
For safety reasons, always use the
¾
safety guard when working with
cutting wheels.
Tightening/loosening the clamping
nut (Fig. I/III)
Tightening the clamping nut
Attention!
The 2 sides of the clamping nut [6] are different.
▸
Screw the clamping nut onto the spindle as
follows:
With thin grinding wheels
• The collar of the clamping nut [6] faces upwards
so that the thin grinding wheel can be securely
clamped.
With thick grinding wheels
• The collar of the clamping nut [6] faces down-
wards so that the clamping nut can be securely
screwed onto the spindle.
22
CAUTION!
▸
Lock the spindle.
▸
Tighten the clamping nut in clockwise direction
using the two-hole wrench [5].
Loosening the clamping nut
▸
Lock the spindle.
▸
Unscrew the clamping nut [6] in anti-clockwise
direction using the two-hole wrench [5].

Operation

Switching ON/OFF

WARNING !
Risk of severe injuries.
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
WARNING !
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
Risk of a dust explosion.
Take care to prevent the machine
¾
from drawing in additional dust and
chips.
Keep away from dust deposits when
¾
switching the machine ON and OFF.
WARNING !
Risk of severe injuries.
If the machine is set to continuous
Â
running, it will continue to run if it is
torn out of your hand.
Always hold the machine with both
¾
hands at the handles provided, take
up a stable posture and concentrate
on the work in hand.
DANGER!