Spektrum AR9110 PowerSafe Bedienungsanleitung Seite 15

Binding
Note: In order for the system to operate, one remote receiver must be
plugged into receiver port A and two more receivers must be plugged into
any other ports. When binding the PowerSafe with three remote receivers,
if a fourth remote receiver is added, the system must be re-bound to
recognize the additional remote.
It's necessary to bind the AR9110 to the transmitter so that the AR9110
will only recognize that specific transmitter, ignoring signals from any other
sources. If the PowerSafe is not bound to the transmitter, the system will
not operate. During binding the servo's failsafe positions are stored.
How To Bind the PowerSafe
1. With the system hooked up and all remote receivers attached as described
previously, insert the bind plug in the BIND/DATA port in the PowerSafe.
2. Turn on the soft switch. Note that the LEDs on all receivers should
be flashing indicating that the receiver is ready to bind.
3. Establish the desired failsafe stick positions, normally low throttle and flight
controls neutral.
4. Follow the procedures of your transmitter to enter it into bind mode. The
system will connect within a few seconds. The LEDs on all receivers should
go solid, indicating the system has connected.
5. Remove the bind plug and store it in a convenient place.
6. After you've programmed your model, it's important to rebind the system so
the true low throttle and neutral control surface positions are programmed.
Binding Telemetry with PowerSafe
Spektrum PowerSafe receivers like the AR9110, AR12110 and the AR7110
require a special binding procedure when using telemetry modules.
1. Insert a bind plug in the bind port in the receiver.
2. Insert the telemetry modules' Data port lead into any un-used channel in the
receiver. (Note: If all channels are being used remove any servo lead from
the receiver to allow an open servo port to be accessed).
3. Power the receiver through the EC3 connector. Note that all the receivers
(internal and remote) should be flashing indicating they are in bind mode.
EN