Nilfisk-Advance IVT 1000 CR Bedienungsanleitung Seite 31

2.3 Grounding instructions
This appliance must be grounded. If it should
malfunction or break down, grounding provides a
path of least resistance for electric current to reduce
the risk of electric shock. The plug must be inserted
into an appropriate socket that is properly installed
and grounded in accordance with all local codes and
ordinances.
WARNING – improper connection of the equipment
grounding conductor can result in a risk of electrical
shock.
Check with a qualified electrician or service person if
you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug supplied with the
appliance – if it will not fit the socket, have a proper
one installed by a qualified electrician.
Attention!!
Under no circumstances must the user tamper with the
equipment.
All attempts by the user or by unauthorised personnel
to dismantle, modify or, more generally, tamper with
any part of the vacuum shall void the guarantee.
Contact your nearest
After-Sales Service Centre in the event of faults.
3 - Machine data
3.1 Identification data.
Always state all the identification data on the machine
when ever you contact Nilfisk-Advance after sales
service.
Exact identification of the machine model and serial
number will help prevent incorrect information from
being given.
The identification plate with the machine data is shown
in fig. 1
A Type
B Electrical Power
C Serial number - yywwXXXX
(yy=year ww = week XXXX = number
D Operating Frequency
E Dust class Category
F Ref. number
G Voltage
H Max. Current
3.2 - Main parts (fig. 2 / 3 / 4)
The following list of main parts will help users to
understand
the terms used in this manual.
Fig 2 standard machine
1. Motor head incl. handle
2. On / Off button
3. Exhaust filter cover
4. ULPA U 15 exhaust filter
5. Top container
6. Main filter "M" class Goretex® PTFE filter
7. Dust container
8. Stainless steel clamps
9. Trolley
Fig. 3 "H" class machine
1. Motor head incl. handle
2. On / Off button
3. Exhaust filter cover
4. ULPA U 15 exhaust filter
5. Top container
6. Vacuum Gauge / Manometer
8. "H" class HEPA H 13 filter
9. Dust container
10. Blind cover for inlet
11. Stainless steel clamps
12. Stainless steel clamps
Fig. 4 "Safe Pack" machine
1. Motor head incl. handle
2. On / Off button
3. Exhaust filter cover
4. ULPA U 15 exhaust filter
5. Top container
7. "Safe pack" unit
8. HEPA H 13 filter fixed inside safe pack unit
9. Stainless steel clamps
10. Trolley
4 - Safety
Attention!!
Check that all clamps are correctly positioned and
working correctly before starting and using the
machine.
Never tamper with the safety devices.
Always check that the protection and safety devices are
mounted and working at the beginning of each work
shift or before using the machine. If this is not the case,
switch off the vacuum and report fault.
The vacuum has been manufactured with particular
attention to the operatorʼs safety.
Comply with the maintenance and technical assistance
procedures and information given in this manual.
Never use compressed air to clean the machine or its
components.
Never open the waste container whilst the vacuum is
operating.
Before beginning electrical connection, check that the
voltage
and frequency values are those indicated on the data
plate of the machine.
Connect the machine to the electricity main with an
efficient ground circuit.
Only authorized personnel must be allowed to work on
the electrical part of the machine and this must always
be disconnected from the electricity main.
Never move the vacuum by pulling the power cable. This
may damage the vacuum itself and the operator may be
exposed to electric shocks
31