Demolition And Disposal - Berkel HOME LINE 200 Gebrauchsanleitung

holder is completely re-
moved.
WARNING!
!
sharp, cutting hazard!
Use protective gloves when
cleaning sharpening areas, the
table, the product holder and
the blade.
Clean the:
- lblade: press a damp cloth on
the surface of the blade and
move it slowly from the centre
toward the outside, as shown
in the figure (Fig. D), on the
blade cover side and the oppo-
site side. In the same way, dry it
using a dry cloth;
- machine body: clean the ma-
chine body with a damp cloth
or a sponge, rinsing with water.
Dry carefully.
Finally, assemble the:
- blade cover:
1) replace the blade cover
as in the figure; 2) rotate the
blade cover 90° clockwise
until it locks into its initial
position (Fig. E);
- meat table:
lift the meat table and move
it to the cutting position,
pressing down lightly until it
clicks.
MAINTENANCE
Blade maintenance
Cleanse the blade regularly to
keep it sharp and functional.
Do not wash the blade in the
dishwasher.
SERVICE
No replacement parts are sup-
plied in the package. All repair
and replacement
(such as replacement or repair
of the blade, belt, electrical
components, structural parts,
etc.) must be carried out solely
by persons authorised by the
Blade is manufacturer.
If a repair is required, it is ad-
visable to return the machine
to the manufacturer or to an
Authorised Service Centre.
For information about services
centres, contact:
service@berkelinternational.
com.
WARNING!
!
must be replaced when the
distance between the edge of
the blade itself and the internal
edge of the protection exceeds 5
mm.
WARRANTY
AND RESPONSIBILITY
The manufacturer provides
machines with a warranty of
24 months starting from the
date of purchase. The warran-
ty covers only those defects if
used properly and according to
the conditions of use provided
by the manual. The warranty
does not cover defects due
to transport, the purchaser's
incompetence or negligence,
improper installation or place-
ment, damage due to wear, or
voltage greater than 10% of
the nominal value. Further-
more, the warranty does not
cover components inherently
subject to wear, such as the
blade and sharpener wheels,
except in the case of obvious
production defects.
The manufacturer declines any
direct and indirect responsibil-
ity stemming from:
- failure to observe the instruc-
activities tions in this manual;
- use which does not conform
to regulations in the country of
The blade
14
installation;
- unauthorised modifications
and/or repairs on the machine;
- use of non original accesso-
ries or replacement parts;
- exceptional event.
The transfer of machine own-
ership involves the immediate
release from any responsibility
by the manufacturer, with the
exception of compliance with
Directive 2006/42/EC (liability
for any manufacturing defect
of the product).
The identification plate at the
base of the machine registers
the manufacturer, the ma-
chine, technical information
and the CE marking.
DEMOLITION
AND DISPOSAL
The machine is composed of:
- aluminium alloy;
- inserts and various compo-
nents in stainless steel;
- electrical parts and electrical
cables;
- electric motor;
- plastic, etc.
If disposal is entrusted to a
third party, contact only au-
thorised companies for dispos-
al of the materials mentioned
above. The device contains ma-
terials which can be recovered
or recycled. Proper separate
collection facilitates recycling.
At the end of machine life, de-
posit in your device at a col-
lection point. Information on
disposal can be obtained from
local authorities.