Elica Synthesis Series Montage- Und Gebrauchsanweisung Seite 12

with a pencil.
c. Unhook the hood and make 2 holes, insert 2 wall
dowels, hang the hood up again and fix definitively with 2
screws and washers.
10. Fix the motor unit to the support structure definitively:
make a Ø3.5 mm pilot hole on the support structure with
a drill, passing through the lower hole inside the motor
housing, after which fix definitively with 1 screw and
washer.
11. Carry out the connection of a tube (tube and strips for
fixing not supplied, to be purchased) for the discharge of
fumes to the connection ring over the suction motor unit.
The other end of the tube must be connected to a device
for the expulsion of fumes outside in the case of using
the hood in the suction version or to deflector F in the
case of using the hood in the filtering version.
12. Connect the electricity.
13. Place the flues and fix them above with 2 screws (20a) to
the „G" (20b) flues support bracket.
14. Slide the lower section of the chimney to cover the
suction unit completely until it inserts into the apposite
seat over the hood.
15. Apply the two side covers - embedded fixture - the parts
are not interchangeable.
Mount the frame of the carbon filter and the fats filter/s again
and check the perfect functioning of the hood.
12