Hendi 212004 Gebrauchsanweisung Seite 6

Note: Due to the manufacturing residues, the ap-
pliance may emit slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
Operation
• Clean the baking surface with a clean damp cloth
before each use & let dry afterwards.
• Connect the power plug with a suitable electrical
outlet. Power indicator (2) will light up in green to
show that it is connected to the electrical power
supply.
• Switch ON the appliance by turning the temper-
ature control (1) in a clockwise direction to select
the required baking temperature.
• Wait for about 15 ~ 20 minutes to let the baking
plate heating up to about 200 ~ 250°C (Max).
• Then, pour a small amount of crepe batter onto
the baking plate with a spoon. Use a wooden
spreader (4) to spread it in circular movements.
Note: Moisten the wood spreader before use. This
prevents the batter from sticking to the spreader
(4).
• Allow the crepe to cook on one side until its
EN
surface is no longer liquid visibly. Use a wood-
en spatula or heat-resistant plastic spatula (not
supplied) to lift one side of the crepe gently. The
crepe should be visibly cooked, may be some
in brown. In this case, the crepe is ready to be
flipped.
RESET the Hi-limiter (thermal cut-out)
Please note that a RESET button is located at the
rear side of the appliance covered with a protective
cap. (See diagram)
• Unplug the appliance from the electrical outlet
first.
• Allow the appliance to completely cool down.
• Unscrew the black protective cap of the RESET
button.
• Press the RESET button of the Hi-limiter (ther-
mal cut-out). You should hear a click sound.
• Screw back the protective cap on the RESET but-
ton.
6
Note: You will need a wooden spreader (4) on hand
before starting to cook crepes, because you have
to handle quickly while baking to avoid overcooking
the batter.
Note: When you pour the batter onto the hot bak-
ing plate, you might hear some slight cracking
noise caused by difference in temperature. This
is normal.
Note: Do not overcook the crepe, or the texture
will become rubbery. The crepe can be cooked
quickly under high temperature. So, it can be
flipped within about 2~3 minutes if you select a
suitable temperature.
• Turn the crepe over to other side carefully. It only
needs to cook on the other side for about 30 ~ 40
seconds.
• Carefully remove the crepe from the baking plate.
Continue making more crepes until you ran out
of batter. Do not use hand to touch the crepe as
it is still hot.
• If necessary, adjust the temperature by rotating
the temperature control.
• Switch OFF the appliance by rotating the temper-
ature control (1) anti-clockwise direction to 0°C.
Attention! Disconnect the power plug when not in
use. Green indicator (2) will go out. Leave the appli-
ance to cool down completely before cleaning and
storing.