12/24 V Car Charger Cable - Powerfix PLS 10 A1 Bedienungsanleitung

Powerfix PLS 10 A1
Use the On/Off switch (9) to switch the battery LED emitter (A) on and off. The On/Off
switch (9) is protected against humidity with a rubber cover. You can recognize the position
of the On/Off switch (9) by looking at this rubber cover. In addition, the switch positions
(ON/OFF) are labelled.

12/24 V car charger cable

In addition to the wall plug battery charger (B) you can also charge the built-in Li-Ion battery
of your battery LED emitter (A) using the 12/24 V car charger cable (C) supplied. To release
this rubber cover (7), pull the red latch. Then connect the wall 12/24 V car charger cable
(C) charging plug to the battery LED emitter (A) DC-IN socket (8) and connect the 12/24 V
car charger cable (C) to a suitable 12/24 V vehicle cigarette lighter. The green LED
indicator on the 12/24 V car charger cable (C) plug indicates that it is ready for operation.
During charging the charge indicator (6) of the battery LED emitter (A) lights red. When the
built-in Li-Ion battery is fully charged, the charge indicator (6) changes to green. Unplug the
12/24 V car charger cable (C) from the vehicle cigarette lighter and then disconnect the
plug from the 12/24 V car charger cable (C) from the DC-IN socket (8). Close the DC-IN
socket (8) with the rubber cover (7). Now the battery LED emitter (A) is ready for use.
English - 23