Maintenance / Cleaning; Servicing; Cleaning; Troubleshooting - Powerfix PLS 10 A1 Bedienungsanleitung

Maintenance / cleaning

Servicing

The battery LED emitter (A) uses a long-life LED. This is not replaceable and requires no
maintenance.
The built-in battery pack is a non-standard battery and not available in retail stores. Therefore
it is not intended for the customer to replace the battery.

Cleaning

Make sure that no liquid gets into the housing. This could damage the battery LED
emitter (A).
To clean the battery LED emitter (A), use a soft, dry cloth. Never use any solvents or cleaners
that may damage the plastic housing. For more stubborn dirt, use a slightly damp cloth.

Troubleshooting

Battery LED emitter does not illuminate
 Check the position of the On/Off switch (9).
 The built-in battery may be discharged. Recharge it.
Battery does not charge
 The wall plug battery charger (B) is defective. Check if you can charge it with the 12/24 V
car charger cable (C).
 12/24 V car charger cable (C) defective. Verify if the green LED indicator on the 12/24 V
car charger cable (C) plug is on after inserting it into a powered cigarette lighter. If not,
replace the fuse of the 12/24 V car charger cable (C) as described in "Replacing the
fuse"
Powerfix PLS 10 A1
English - 25