Playing Chases - EuroLite DMX OPERATOR 1610 Bedienungsanleitung

Inserting a step
It is possible to insert scenes before the current editing position.
1. Enable programming mode.
2. Select the chase you want to add a step to with one of the CHASE buttons.
3. Press the INSERT/TAP button (corresponding LED flashes). Now, a scene can be inserted before the current
editing position.
4. Use the buttons ⊳ and
5. Adjust the desired scene or select it form a memory location that contains scenes.
6. Shortly press EDIT/REC to memorize the revised chase. To confirm the memory procedure, all LEDs of the
controller flash three times.
7. Exit programming mode.
Deleting a step
It is possible to delete a scene from a chase at the current editing position.
1. Enable programming mode.
2. Select the chase you want to add edit with one of the CHASE buttons.
3. Use the buttons ⊳ and
4. Press the button DEL/CLEAR to delete. To confirm the deleting procedure, all LEDs of the controller flash
three times.
5. Exit programming mode.
Deleting chases
1. Enable programming mode.
2. Keep DEL/CLEAR pressed. Now additionally press the CHASE button of the chase you want to delete. To
confirm the deleting procedure, all LEDs of the controller flash three times.
3. Exit programming mode.

Playing chases

A chase must be programmed before you can call it. Chases can be played manually, time-controlled or sound-
controlled. Use the RUN MODE button (15) to select the operating mode. The LEDs MANUAL, AUTO and MUSIC
indicate the current setting. It is possible to select up to 16 chases simultaneously. They are played one after the
other. The control LED of the chase currently playing flashes, the others light.
Manual mode
1. Switch to manual mode with the RUN MODE button.
2. Call the desired chase with the CHASE buttons. Press the button again to stop the chase.
3. Use the buttons ⊳ and
4. Use the FADE TIME control to set the fading time of the current scene.
Automatic mode
In automatic mode, the scenes stored in a memory bank will be played time-controlled in a loop. The number of
repetitions is adjustable.
1. Switch to automatic mode with the RUN MODE button.
2. Call the desired chase with the CHASE buttons.
3. Use the control WAIT TIME to adjust the running speed and the control FADE TIME to adjust the fade time.
Repeatedly press INSERT/TAP for a more precise input of the running speed. The interval of the last two
respective keystrokes defines the speed.
4. Use the buttons ⊳ and
to jump from one step to the next. The display indicates the current editing position.
to select the step to be deleted.
to jump from one step to the next
to adjust the number of repetitions for the chase.
17 • EN