Overheating Protection; Technical Data - RUSTA 906512020201 Gebrauchsanweisung

ENG
USE
• Screw the accompanying feet into the heater
using the provided screws (see figure).
• Minor smoke emission is normal when the
heater is switched on for the first time or
if it has not been used for a long time. The
smoke disappears after a few minutes.
• Choose a suitable and safe location for the
heater (read the safety instructions).
• Insert the plug in the electrical outlet.
• Switch on the heater with the two switches
on the side of the heater. The switches illu-
minate when the heater is switched on. Use
both switches for the highest heat.

OVERHEATING PROTECTION

The heater is equipped with overheating protection which disconnects the current if the
heater overheats due to improper use (e.g. if it is covered). The overheating protection
automatically switches off when the heater has cooled down.
CLEANING
• Always pull the plug out of the electrical outlet and let the heater cool down.
• Clean the outside with a damp cloth and dry with a dry cloth.
• Do not use any corrosive or abrasive cleaners which can damage the heater's surface.
• Water or other liquids must not penetrate into the heater.
STORAGE
Store the heater in a clean and dry location when it is not in use for an extended period of time.

TECHNICAL DATA

Voltage 230V~50Hz
Output 650W = 85°C, 850W = 93°C, 1500W = 130°C
4