Cleaning And Care - Waeco COOLMATIC CRD50 Montage- Und Bedienungsanleitung

CD50, CRD50
8.4 Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
➤ Set the temperature control knob (fig. 2 1 page 3) to level "0".
➤ Disconnect the power cable from the battery or pull the AC cable plug out
of the rectifier.
➤ Clean the refrigerator (see chapter "Cleaning and care" on page 43).
➤ Turn the locking wheel (fig. a 1, page 7) anti-clockwise to the end stop
("Vent").
➤ Close the door until it latches in.
✓ The door stays open thus preventing smells from arising.
9

Cleaning and care

!
WARNING!
Always disconnect the device from the mains before you clean
and service it.
A
NOTICE! Risk of damage
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
 Never use hard or pointed tools to remove ice or to loosen
objects which have frozen in place.
➤ As soon as the refrigerator becomes dirty, clean it with a damp cloth.
➤ Make sure that no water drips into the seals. This can damage the elec-
tronics.
➤ Wipe the refrigerator dry with a cloth after cleaning.
EN
Cleaning and care
43