Cleaning And Maintenance - Waeco MyFridge MF05 Bedienungsanleitung

Cleaning and maintenance

➤ Plug the 220 – 240 V connection cable (fig. 1 3, page 3) into the AC
voltage socket and connect it to the 220 – 240 V AC mains supply.
➤ Push the switch (fig. 2 3, page 3) on the control panel to "HOT" or
"COLD" to switch the device on.
✓ The refrigerator starts cooling/heating the interior and the appropriate
LED lights up.
➤ MF15 only: Push the ECO switch (fig. 2 6, page 3) to the desired posi-
tion.
➤ If you wish to switch the refrigerator off:
– Slide the switch (fig. 2 3, page 3) to the "OFF" position
➤ Pull out the connection cable.
I
NOTE
If you are not going to use the refrigerator for a long time, leave
the door slightly ajar to prevent unpleasant odours building up.
7 Cleaning and maintenance
!
WARNING!
Always disconnect the device from the mains before you clean
and service it.
A
NOTICE! Risk of damage
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
22
MF05, MF15
EN