Toshiba RBC-ASC11E Gebrauchsanweisung Seite 6

10 Fan speed indication icon
• Indicate the selected fan speed. (Three-
speed models)
• Indicate the selected fan speed. (Five-speed
models)
3 Operation
When you use the air conditioner for the first time or change the settings, please follow the steps
below.
From then on, press the On/Off button to run the air conditioner with the selected settings.
■ Standby
When "SETTING" flickers, the operation will not be accepted by system.
Requirements
·During use, keep the power switch in open state.
· When you use it again after a long time, please turn on the power switch at least 12 hours in
advance.
·About 1 minute after the power is turned on, the remote controller can work. This is not a fault.
11 Timer off indication icon
When an error occurs, display the error code. In
normal state, display the time of timer off.
12 Preheating indication icon
Display when the heating mode or the defrosting
cycle starts. When this indication icon is displayed,
the indoor unit stops the air supply or runs in the
fan mode.
13 Running standby indication icon
Indicate that if another indoor unit is under heating/
cooling, Toshiba Super Smart multi-connection
system cannot cool/heat; Moreover, the super heat
recovery multi-connection system cannot heat or
cool because the outside temperature exceeds the
operating temperature range.
14 Remote controller sensor indication icon
Display when using the remote controller sensor.
15 Self-cleaning operation display
Display when the indoor unit heat exchanger is
dehumidified by the self-cleaning operation.
-4-