Adjusting The Compressed Air; Adjusting The Torque; Initial Use; Changing Rotation - Parkside PDSS 310 A1 Bedienungs- Und Sicherheitshinweise

Commissioning
First wrap a piece of Teflon tape (not included)
around the outer threads of the plug nipple
and the lubricator
Now screw the plug nipple
of the lubricator
11
Tighten this connection with moderate force
and absolutely using pliers.
Now turn the combination of lubricator
plug nipple into the connection thread
9
of the impact driver (see Fig. C).
Also retighten this connection with pliers.
Now press the air hose onto the plug nipple
using a little force, until the hose locks in.
ATTENTION! Be sure the air hose
is firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two screw
connections between lubricator
and machine are securely seated.

Adjusting the compressed air

Note: this device is designed for an operating
pressure of up to 6.3 bar and a compressor with
the minimum air flow specified in the technical spe-
cifications. When setting the air pressure, remember
the pressure drops by approx. 0.6 bar with a hose
length of 10 m and an inside diameter of 9 mm.
Only use filtered, lubricated and regulated
compressed air.

Adjusting the torque

Set the torque control
by pressing it toward the housing and turning it
until it locks at the desired setting.
Be sure the operating pressure of the compres-
sor is between 5 and 6.3 bar.
Note: the ideal pressure is 6.3 bar. The maximum
torque cannot be reached at a pressure of only 5
bar or with insufficient air flow.
12 GB/CY
96878_par_Druckluft-Schlagschrauber PDSS 310 A1_content_HR_RO_BG_GR_CY.indd 12
9
(see fig. B).
11
into the thread
9
(see Figure C).
and
11
2
9
, coupling
11
to the correct torque
3
Setting
1 (low, min.)
2 (normal)
3 (high)
4 (extra high,
max.)

Initial use

Activate the trigger
4
Release the trigger
4
ment.

Changing rotation

ATTENTION! The device must come to a
complete standstill before changing the direc-
tion of rotation.
ATTENTION! A machine rotating in an unex-
pected direction can be dangerous. Always
pay attention and use care.
Note: The impact driver clockwise / counter-
clockwise rotation. Use the reverse switch
to change the direction of the impact driver.
Pull the bolt forward in the direction of the „F"
marking („Forward / Fasten") for clockwise
operation. You can now e.g. tighten screws.
Push the bolt back towards the „R" marking
(„Reverse / Release") so it protrudes from the
back of the equipment to set to counter-clock-
wise mode. You can now e.g. loosen screws.
Correctly holding the
equipment
This equipment weighs 2.3 kg.
Hold the equipment with both hands to ensure
safe operation (see Fig. D and E).
to start the equipment.
to deactivate the equip-
6
23.04.14 16:24