Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting; Adjusting The Compressed Air; Adjusting The Torque; Initial Use - Parkside PDSS 310 A3 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Commissioning

Connecting

Note: only use connection hoses with a minimum
inside diameter of 9 mm.
First wrap a piece of Teflon tape (not included)
around the outer threads of the plug nipple
and the lubricator
Now screw the plug nipple
of the lubricator
You must use an open-end spanner to tighten
this connection with moderate force.
Now turn the combination of lubricator
plug nipple
into the connection thread
9
of the impact driver (see Fig. C).
Also retighten this connection with an open-end
spanner.
Now press the air hose onto the plug nipple
using a little force, until the hose locks in.
ATTENTION! Be sure the air hose
is firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two screw
connections between lubricator
and machine are securely seated.

Adjusting the compressed air

Note: this device is designed for an operating
pressure of up to 6.3 bar and a compressor with
the minimum air flow specified in the technical spe-
cifications. When setting the air pressure, remember
the pressure drops by approx. 0.6 bar with a hose
length of 10 m and an inside diameter of 9 mm.
Only use filtered, lubricated and regulated
compressed air.

Adjusting the torque

Set the torque control
by pressing it toward the housing and turning it
until it locks at the desired setting.
Be sure the operating pressure of the compres-
sor is between 5 and 6.3 bar.
54 GB
275671_par_Druckluft-Schlagschrauber PDSS_content_AT_CH.indd 54
(see fig. B).
11
into the thread
9
(see Figure C).
11
11
, coupling
11
to the correct torque
3
Note: the ideal pressure is 6.3 bar. The maximum
torque cannot be reached at a pressure of only 5
bar or with insufficient air flow.
Setting
9
1
(low, min.)
2
(normal)
3
(high)
and
4
(extra high,
2
max.)

Initial use

9
Activate the trigger
Release the trigger
ment.

Changing rotation

ATTENTION! The device must come to a
complete standstill before changing the direc-
tion of rotation.
ATTENTION! A machine rotating in an unex-
pected direction can be dangerous. Always
pay attention and use care.
Note: The impact driver clockwise / counter-
clockwise rotation. Use the reverse switch
to change the direction of the impact driver.
Push the bolt forward in the direction of the „F"
marking („Forward / Fasten") for clockwise
operation. You can now e.g. tighten screws.
Push the bolt back towards the „R" marking
(„Reverse / Release") so it protrudes from the
back of the equipment to set to counter-clock-
wise mode. You can now e.g. loosen screws.
to start the equipment.
4
to deactivate the equip-
4
6
09.05.16 14:13

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 285198

Inhaltsverzeichnis