Beem 3008C Bedienungsanleitung Seite 30

EN
In the case of tea bags, it is essential to note the manufacturer's preparation instruc-
tions.
Proceed as follows to make green tea:
1. Pour water into the water reservoir (5) (see the "Operation" chapter | "Filling the Water
Reservoir").
2. Fill the tea strainer (1) in the teapot (2) with tea leaves or tea bags.
Green tea generally has a lower concentration than black tea. Roughly 1 g is added
to 100 ml of water or 1 heaped teaspoon is added to 200 ml of water.
3. Place on and close the lid (15) (see the "Operation" chapter | "Removing / Attaching
the Lid").
4. Place the teapot on the lid. This will preheat the teapot while the water is boiling.
5. The cups are also preheated by being fi lled with warm water.
6. Turn the control dial (6) to the highest temperature (
start boiling the water. The
7. As soon as the water boils, turn the control dial down to
cool down for approx. 5 – 6 minutes.
8. Take the teapot off the water reservoir.
9. Brew the tea in the teapot with warm water from the water reservoir (see the
"Operation" chapter | "Operating the Discharge Tap").
10. Place the teapot back on the water reservoir. The steam rising up in the water
reservoir keeps the tea concentrate in the teapot at the temperature that it requires for
"infusion".
11. After the required infusion time, take the tea strainer out of the pot.
12. Pour the concentrate that has been created in the teapot into a tea cup or a tea glass
and top it up with hot water from the water reservoir. This enables you to vary the
strength and the fl avour of the tea as you wish.
Herbal Tea
Herbal tea and other types of tea such as fruit, rooibos and spiced teas are made in the
same way as black tea (see the "Tips For Making Tea" chapter | "Black Tea"). Depending
on the variety, the different mixtures require an infusion time of approx. 5 – 10 minutes.
In rare cases, herbal tea mixtures may contain germs (such as salmonella) which are
killed off by being heated. Herbal tea must therefore always be infused using boiling
water. This is the only way to obtain a safe product to consume!
heating control lamp
) to switch on the device and
(11) lights up.
and allow the water to
32