Cleanmaxx PC-P008E Gebrauchsanleitung Seite 25

3. Push the release button on the dust container and empty it.
5. If necessary, clean the dust container and the dust fi lter with clean, lukewarm
water.
NOTICE: Do not clean the HEPA fi lter with water!
6. Allow all parts to dry completely before assembling them.
NOTICE: Do not in any case insert the dust fi lter if it is still moist. Reverse
the steps to assemble them. Make sure that the catches on the dust container are
inserted into the corresponding recesses on the main unit. Otherwise, the dust
container will not correctly lock into the device.
Cleaning the Main unit, Extension Tube and Nozzles
• Wipe down the main unit (3), extension tube and nozzles with a damp, soft cloth if
necessary. Then dry them with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
Cleaning the Turbo Nozzle
To make it easier to clean, the brush can be removed from the turbo nozzle (9):
Storage
• Store the device in a cool, dry place which is protected from direct sunlight and is
out of the reach of children and animals.
If you do not want to use the device for a prolonged period, remove the re-
chargeable battery to stay on the safe side (see section "Removing the re-
chargeable battery").
25
possible so that the dust does not spread in the surroun-
ding air.
4. Pull the fi lters out of the dust container: Turn the dust
fi lter approx. one quarter turn counterclockwise and
remove the dust fi lter with the HEPA fi lter. Knock all parts
out over a rubbish bin and brush them off if necessary.
1. Slide the latch fastener on the bottom of the turbo nozzle
towards the small wheel on the turbo nozzle.
2. Open and remove the latch.
3. Take out the brush and remove any contamination.
4. Reinsert the brush. When you do this, fi rst insert the end
with the star-shaped recess.
5. Insert the latch and slide the latch fastener back in place.
EN