GB
Install guiding roller:
Insert the guiding roller (11) on to the
motor head (8). Only one position is
possible.
Mounting the additional handle:
1. Unscrew the additional handle
(5).
2. Set the additional handle on the
upper telescopic arm (7).
3. Push the clip (15) into the slot on
the additional handle and fasten
the clip and the handle at the
desired height, using the handle
screws (16).
Operation
Caution, risk of Injury!
Always check whether the de-
vice functions correctly before
using it. Make sure that the net
voltage matches the voltage
rating indicated on the device's
type plate.
Always wear eye protection
when operating the device.
Always disconnect the power ca-
ble and wait until the brush has
stopped completely, before per-
forming any work on the device.
Injury hazard!
Observe the noise protection and
other local regulations. .
Switching ON and OFF
1. Form a loop in the end of the ex-
tension cable, conduct it through
the opening in the handle (1)
20
and hang it on to the strain relief
(3).
2. Connect the device to the mains
socket.
3. Press the on/off switch (2) to
start the device.
4. To turn it off, release the on/off
switch (2). The device cannot be
switched to continuous opera-
tion.
The brush will keep rotating for a
few seconds after the device has
been switched off. Keep the brush
away from hands and feet.
Do not try to lock the on/off
switch in place. Do not use the
device if the switch is damaged.
A damaged switch may cause an
injury risk due to the motor not
being switched off after releas-
ing the on/off switch.
Device adjustments
Adjusting the additional handle:
You can adjust the additional handle's
height.
Unfasten the handle screws (see il-
lustration
additional handle (5) to the desired
position. Retighten the handle screws.
Length adjustment:
The telescopic arm enables you to adjust
the device to your individual height.
Unfasten the screw socket (6). Adjust
the telescopic arm (7) to the desired
length and re-fasten the screw socket.
16) and adjust the