Initial Start-Up; Assembly; Mounting The Handgrip With Extension Rod; Operation - Grizzly HUV 600-2000 Originalbetriebsanleitung

GB
nufacturer or their customer
service or by a similarly qua-
lified person in order to avoid
hazards.
• Do not connect a damaged
mains cable to the power sup-
ply. Do not touch a damaged
mains cable as long as it is
connected to the power supply.
A damaged mains cable can
result in voltage-carrying parts
being touched.

Initial start-up

When used for the first time, some smo-
ke may escape. The smoke is caused
by binders which are removed from the
insulating film of the heater by the heat
during first use. To ensure that the smoke
escapes quickly, the device should be
placed on the stand area. The working en-
vironment should be ventilated well during
first use.

Assembly

Mounting the handgrip
B
with extension rod
Mount the handgrip with extension rod (1)
to the housing's short hand grip (4) by in-
serting the bayonet locking device (
into the opening of the short handgrip (4)
and rotating it 90 degrees until the stop.

Operation

Switching ON and OFF

Change the step switch (
"I". The device reaches an air quantity of
500 l/min at 50 °C.
16
11)
5) to level
Change the step switch (
"II". The device reaches an air quantity of
500 l/min at 600 °C.
Change the step switch to level "0" to
switch it off.

Use of adapter nozzles

Before exchanging adapter noz-
zles, the adapter nozzle (
and blow-off pipe (
sufficiently cooled down to avoid
burns.
Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.

Surface nozzle

Insert the surface nozzle (9) onto the
groove on the blow-off pipe (12) and lock
it by turning it counterclockwise.
Use the surface nozzle (9) to obtain heat
over a large surface.
When using the surface nozzle (9),
pay particular attention to the heat
development in adjacent locations
of the cutting point. So that in ca-
ses of doubt, no adjacent compo-
nent is overheated.

Grill lighter nozzle

Place the grill lighter nozzle (
blow-off pipe ( 12).
Change the device with the step switch
( 5) to level "II". Place the grill lighter
nozzle ( 10) below the charcoal. In just
a few minutes the charcoal is ignited.
5) to level
9/10)
12) must be
10) on the