GUTMANN Futura Montageanleitung Seite 8

en
3.) Insert hood module (a) into cabinet below
and align it so that it is located centrally under
the cut-out section. For reasons of space, it
is recommended to implement this work
before the cooking surface (j) is installed.
3
b
4.) Carry out the height adjustment on the
mounting feet (e, page 31), so that the panel
(c) and cover plate (g) are flush; pay attention
to parallel mounting
b
g
c
1
e
c
j
5.) Now carry out the fixing of the hood
module (a) with the mounting angles (f) with
respect to the work top/cabinet below.
6.) Attach the exhaust hose to the vent nozzle
(d) by means of hose clamp. Ensure that the
exhaust hose is laid without kinking.
7.) Establish the electrical connection (h) to
the mains.
8.) Now pull out the bonnet (ensure that,
during the pull-out, no objects or parts of the
body are located in the direct proximity,
danger of crushing!), where appropriate, re-
adjust bonnet on mounting feet (e) or
mounting angles (f). Bonnet may not streak
when pulling out.
2
Before the bonnet is lowered again the glass
element (L) must be inserted. In this case
ensure that the glass holders are attached
parallel in the guide pins, and that the lower
edge of the glass element (L) is located in
the glass receptacle (o).
a