Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
4. Create fastening for tower bracket (a).
5. Screw the hanger bolts into the dowels
(Ø10 mm) until approx.. 20 mm protrude.
6. Suspend the extractor hood and loosely
tighten it using washers and nuts.
7. Align the extractor hood (check mounting
dimensions), then tighten the nuts.
8. If necessary, additionally fasten the
extractor hood with two screws.
9. (Extraction mode) Cut the exhaust air hose
to the correct length.
10. (Extraction mode) Attach and fasten the
exhaust air hose to the support (d), making
sure that the hose is not bent.
11. Make the electrical connection (e).
(Extraction mode) If using an external blower
motor, connect the connecting cable.
12. Bend the holding notches on the upper
tower (b) outwards by approx . 2-3 mm.
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
