Positioning Servos; Positioning Servos Via The Servo Control; Positioning Servos Via A Digital Control Unit - Faller 180725 Bedienungsanleitung

Presetting servos
CV Description
183 Hold position "green" Address 2
»Servo 4« port
150 HighByte Address 1
151 LowByte Address 1
152 Hold position "red" Address 1
153 Hold position "green" Address 1
154 Positioning time
155 Rocking amplitude Hold position "red"
Address 1
156 Rocking time Hold position "red" Address 1
EN
157 Rocking amplitude Hold position "green"
Address 1
158 Rocking time Hold position "green"
Address 1
159 Reset time 0.5 s steps
190 HighByte Address 2
191 LowByte Address 2
192 Hold position "red" Address 2
193 Hold position "green" Address 2
Tab. 3: Synopsis of all configuration variables (CV).
* ADVICE: If you use a Motorola digital control unit, default settings for the
addresses of configuration variables 121, 131, 141 and 151 are not available.
52
ANLAGENBAU
Range Default
setting
0-127 0
0-8 0
0-255 7*
0-127 30
0-127 95
0-255 40
0-127 0
0-255 0
0-127 0
0-255 0
0-255 0
0-8 0
0-255 0
0-127 0
0-127 0
ANLAGENBAU
6.

Positioning servos

The Servo Control allows you to position servos in two different ways:
ƒ

Positioning servos via the Servo Control

ƒ

Positioning servos via a digital control unit

Positioning servos via the Servo Control
Servos that are connected to the Servo Control can be positioned via the
Servo Control.
Prerequisite conditions:
ƒ The Servo Control is connected to the supply voltage.
ƒ A servo is connected to the Servo Control.
ƒ For each servo position a push button is connected to the Servo Control.
ƒ
The servo has been preset.
Press a push button that is connected to the Servo Control.
X
Positioning servos via a digital control unit
A servo can easily be positioned via a digital control unit.
Prerequisite conditions:
ƒ The Servo Control is connected to the supply voltage.
ƒ
The Servo Control is connected to a track output of a digital control unit.
ƒ A servo is connected to the Servo Control.
ƒ That servo has been preset via the digital control unit.
Press a control key you have programmed when presetting the servo
X
via the digital control unit, see Chapter „Presetting servos via a digital
control unit", page 44.
Positioning servos
EN
53