Connecting Push Buttons; Presetting Servos; Presetting Servos Via The Servo Control; Presetting Servos Via A Digital Control Unit - Faller 180725 Bedienungsanleitung

Connection

Connecting push buttons

For each servo position you may connect a push button.
Fig. 5: Connecting push buttons
Connect one or several push buttons to one or several of the »Pos A
X
Servo 1« to »Pos A Servo 4« ports and »Pos B Servo 1« to »Pos B Servo
4« ports on the Servo Control, see Fig. 5.
EN
Fig. 6: Connect the return wires of the push buttons
For each push button, connect the return wire of the push button to
X
one of the »0V« ports on the Servo Control, see Fig. 6.
40
ANLAGENBAU
5.
The Servo Control allows you to preset servos in three different ways:
ƒ
ƒ
ƒ

Presetting servos via the Servo Control

Servos are preset directly via the keys on the Servo Control. On doing so,
you are able to preset both hold positions of the first address and the motion
rate of the servo.
In programming mode the unit will always go through the following possi-
ble presettings one after the other:
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ADVICE: During the entire programming procedure you may leave the pro-
gramming mode by pressing the »Prog« key. The settings you have per-
formed up to that moment will not be saved.
Prerequisite conditions:
ƒ
ƒ
X
ANLAGENBAU

Presetting servos

Presetting servos via the Servo Control

Presetting servos via a digital control unit

Presetting servos via configuration variables (CV)

Programming path analog or digital
Connecting the required servo
First hold position of the servo
Second hold position of the servo
Motion rate of the servo
Automatic return (after going to position A) and modifying the return
time
Permanent working (Automatic continuous operation)
The Servo Control is connected to the supply voltage.
A servo is connected to the Servo Control.
Press the »Prog« key.
Presetting servos
EN
41