Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Presetting servos
»Prog« LED lights up. The programming mode is activated.Press the
»+« key.
The analog programming path is activated.
»Servo 1« LED lights up.
Using the »+« and »-« keys, select the port of the servo that you want
X
to preset.
ADVICE: If the servo does not move after the next step, this means that polar-
ity is reversed at the connector. In such a case simply rotate the plug by 180°.
Press the »Enter« key.
X
The servo connected to the selected port briefly moves.
X
Using the »+« and »-« keys, preset the first hold position of the servo
X
(hold position "red"). By keeping the keys pressed, you will also be able
to perform large changes of position easily.
Press the »Enter« key.
X
EN
The servo moves to the second hold position.
X
Using the »+« and »-« keys, preset the second hold position of the servo
X
(hold position"green"). By keeping the keys pressed, you will also be
able to perform large changes of position easily.
Press the »Enter« key.
X
The servo moves to and fro between both preset hold positions.
X
Using the »+« and »-« keys, preset the motion rate of the servo.
X
Press the »Enter« key.
X
Using the »+« and »-« keys, increase or reduce the return time of the
X
servo according to the following table.
ADVICE: The LEDs above the servo ports indicate the value for the return
time. If all LEDs are flashing, then the time will be zero and there will not
be any automatic return.
LED Servo output
1
2
3
All LEDs are flashing
on
off
off
off
on
off
on
on
off
42
ANLAGENBAU
Time
4
No return
off
1 s
off
3 s
off
5 s
ANLAGENBAU
LED Servo output
off
off
on
off
on
off
on
off
off
on
on
off
on
on
on
off
off
off
off
on
on
off
off
on
off
on
off
on
on
on
off
on
off
off
on
on
on
off
on
on
off
on
on
on
on
on
on
on
Tab. 2: Meaning of the LEDs for the return time
Press the »Enter« key to confirm the new return time you have chosen.
X
ADVICE: If return time is greater than zero, you will be able to set the servo
output to the »Permanent working« mode when taking the next step.
Prerequisite conditions: LEDs 1+3 or 2+4 above the servo ports are flashing:
LEDs 1+3 = Automatic return, LEDs 2+4 = Permanent working.
Press the »+« key to activate the »Permanent working« mode or press
X
the »-« key to switch the »Permanent working« mode off.
Press the »Enter« key to confirm the selected mode, to save the preset
X
values, and to complete the programming procedure.
Permanent working (Address=0 and return time > 0)
When programming for digital operation the digital format and the
X
address of the servo are not modified. However, if the relevant servo
output is put in the »Permanent working« mode, then the address will
be set to zero.
The settings are saved.
The LED of the programmed servo port goes out.
»Prog« LED flashes at lower heart rate.
Presetting servos
Time
7 s
11 s
15 s
20 s
25 s
30 s
35 s
40 s
45 s
55 s
EN
65 s
75 s
43
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
