Connection; Connect The Servo Control - Faller 180725 Bedienungsanleitung

General view of product
Ports Description
»16 VAC« Port for the supply voltage
(16 V alternating voltage)
»Servo 1« to Ports with specific pin assignment, for four servos
»Servo 4«
»Digital« Port for a digital control unit to program the servo
»Pos A Servo 1« to Ports for keys that call up the first hold position
»Pos A Servo 4« in the respective servos ("red keys")
»Pos B Servo 1« to Ports for keys that call up the second hold position
»Pos B Servo 4« in the respective servos ("green keys")
»0V« Common return wire for all keys connected to POS
A and POS B (5x)
EN
Keys Description
»Enter« To confirm inputs
»-« »Minus sign key«
»+« »Plus sign key«
»Prog« To activate the programming mode
LEDs Description
»Prog« Flashes at lower heart rate whenever the Servo
Control is properly connected to the power supply
Lights up whenever the programming mode is acti-
vated
»Servo 1« to Lights up whenever a servo is selected in the pro-
»Servo 4« gramming mode
ADVICE: »Servo 1« to »Servo 4« LEDs have in
programming mode further meanings that will be
described in the relevant place.
Tab. 1: Operating elements
36
ANLAGENBAU
4.

Connect the Servo Control

The Servo Control operates on 16 V alternating voltage.
X
ANLAGENBAU

Connection

TIP
The required alternating voltage can be made available using
FALLER 50 VA, 50–60 Hz transformer, Art. no. 180641, for instance.
Fig. 2: Connecting the supply voltage
Connect a 16 V alternating voltage to the »16 VAC« port of the Servo
Control, see Fig. 2.
»Prog« LED flashes at lower heart rate.
Connection
EN
37