Connecting Servos; Connecting A Digital Control Unit - Faller 180725 Bedienungsanleitung

Connection

Connecting servos

You may connect up to four servos to the Servo Control.
Fig. 3: Connecting servos
ADVICE: »Servo 1« to »Servo 4« ports are protected against reversed polar-
ity. If you have wrongly connected the supply cable of a servo by mistake,
the Servo Control will not be able to address the servo. In such a case sim-
EN
ply rotate the plug by 180°.
Connect one or several servos to one or several of the »Servo 1« to
X
»Servo 4« ports on the Servo Control, see Fig. 3.
38
ANLAGENBAU

Connecting a digital control unit

The Servo Control is compatible with DCC and Motorola digital systems.
ADVICE: A digital control unit and the Servo Control may not under any
circumstances be connected to the same transformer.
X
X
ANLAGENBAU
TIP
If you connect the Servo Control to a digital control unit, you will be
able to preset the servos effortlessly via the digital control unit even
though the Servo Control has been built into your installation already.
Fig. 4: Connecting a digital control unit
If you want to preset servos via a digital control unit, connect the »Dig-
ital« port of the Servo Control to a programming track port of the digi-
tal control unit, see Fig. 4.
If you want to position servos via a digital control unit, connect the
»Digital« port of the Servo Control to a track output of a digital con-
trol unit, see Fig. 4.
Connection
EN
39