Welcome To Faller's World; Safety And Responsibility; Proper Use; For Your Safety - Faller 180725 Bedienungsanleitung

Welcome to FALLER's world

1. Welcome to FALLER's world
Congratulations – You have found the right thing!
The Servo Control you have acquired is a control system that will allow you
to connect and actuate up to four commercially available servos independ-
EN
ently of each other. You may want to use such servos to change the posi-
tion of points for instance, to move swivel water spouts, or to open and shut
barriers of level-crossings and gates of engine sheds.
Servos can be preset either directly through that Servo Control or via an
additional digital control unit connected to it. On doing so, you will be able
to preset up to four hold positions of the servo, its motion rate and even a
rocking function that imparts the barriers of level crossings a very realistic
opening and shutting motion.
Your Servo Control operates like a points decoder and is allocated within a
digital control unit a coil item address for each servo. The coil item control
within the digital control unit will then allow you to move the servos to var-
ious hold positions. Servos can also be preset using configuration variables
(CV) by means of a digital control unit that supports the DCC data format.
Gebr. FALLER GmbH wishes you a lot of creative ideas and plenty of fun
with your new acquisition!
32
ANLAGENBAU
2.

Proper use

This product is a scale modeling article aimed at ambitious modellers and
collectors, and no toy. It is designed for use on a model installation. It may
exclusively be operated together with the accessories and add-on devices
recommended by FALLER. Basically, FALLER products are developed and
designed for the hobby sector, not for permanent operation. This product
is intended for use at average ambient temperature and relative humid-
ity. Please operate the product only indoors, and avoid any atmospheric
influences. Any other use will be considered not to be in conformity with
the proper use or intended purpose. Gebr. FALLER GmbH will assume no
responsibility for any damage or defect resulting from improper use or the
non-observance of the directions given in the instruction manual or the
accompanying safety recommendations.
Operating and storage conditions
X
X

For your safety

X
X
ANLAGENBAU

Safety and responsibility

Observe the following operating conditions: 15 °C - 40 °C, up to 75 %
relative humidity, do not allow the formation of dew.
Observe the following storage conditions: 10 °C - 60 °C, up to 85 %
relative humidity, do not allow the formation of dew.
Carefully read through the instruction manual and the accompanying
safety recommendations before use.
Pay attention to the safety recommendations and warnings given in
the instruction manual, in the accompanying safety recommendations
or provided on the product.
Safety and responsibility
EN
33