Technical Data; Before Starting The Equipment - Matrix KS 200-1 Originalbetriebsanleitung

purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.

4. Technical data

Rated voltage:
Power input:
Idle speed:
Adjustment angle:
Grinding wheel Ø (inside):
Grinding wheel Ø (outside):
Grinding wheel thickness:
Sound pressure level measured L
Sound power level measured L
Vibration:
Totally insulated:
Weight:

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Assembly (Fig. 3-6)
. Place the chain clamping mechanism in the
chuck (Fig. 3) and screw from underneath using
the star screw (Fig. 4)
. Before starting the chain sharpener, fasten it
securely to a suitable surface (e.g. a workbench)
at a suitable place (protected against dust, dry,
well-lit) using M8 ixing screws and washers (Fig.
5)
14
230V ~ 50Hz
220 watts
7500min
35º to the left and right
10mm
max. 100mm
3,2/4,5mm
:
pA
87 dB(A), K=3
:
wA
100 dB(A), K=3
2
3,73 m/s , K=1,5 m/s
II /
1,75kg
. Make sure when doing so that the mounting
plate of the chain sharpener is pushed onto the
surface as far as it will go (Fig. 6)
6. Operation (Fig. 7-11)
Important! Always switch the appliance of and
unplug the power plug before making any
adjustments.
6.1 Insert the chain that is to be sharpened
into the chain bar (Fig. 7)
To do this, loosen the chain locking screw (1)
6.2 Set the grinding angle according to the
-1
speciications for your chain (Fig. 8) (normally
between 30-35º)
. Slacken the locking screw for setting the
grinding angle (1)
. Set the desired grinding angle using the scale (2)
. Tighten the locking screw (1) again
2
6.3 Set the chain stopper (Fig. 9)
. Fold the chain stopper (1) onto the chain
. Pull the chain backwards against the chain
stopper (1) until the latter stops a cutting link (2)
Important! You must make sure that the angle
of the stopped cutting link coincides with the
grinding angle. If it does not, pull the chain one
link further.
. Fold the grinding head (4) down until the
grinding wheel (5) is touching the chain link (2)
that is to be ground. (To do so, you can move
the chain back and forth a little using the setting
screw of the chain stopper (3)
6.4 Set the depth limit (Fig. 10)
. Fold the grinding head (4) down and set the
grinding depth using the setting screw (7)