Special Safety Instructions - Matrix KS 200-1 Originalbetriebsanleitung

nonskid footwear are recommended when
working outdoors. Wear protective nair covering
to contain long hair.
9. Use safety glasses
– Also use face or dust mask if cutting operation
is dusty.
10. Don't abuse cord
– Never carry tool by cord or yank it to disconnect
it from receptacle. Keep cord from heat, oil and
sharp edges.
11. Secure work
– Use clamps or a vise to hold work. It's safer
than using your hand and it frees both hands to
operate tool.
12. Don't overreach
– Keep proper footing and balance at all times.
13. Maintain tools with care
– Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords
periodically and, if damaged, have repaired by
authorized service facility. Inspect extension
cords periodically and replace if damaged. Keep
handles dry, clean and free from oil and grease.
14. Disconnect tools
– When not in use, before servicing, and
when changing accessories such as blades, bits
and cutters.
15. Remove adjusting keys and wrenches
– Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
16. Avoid unintentional starting
– Don't carry plugged-in tool with inger on
switch. Be sure switch is of when plugging in.
17. Outdoor use extension cords
– When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
12
18. Stay alert
– Watch what you are doing. Use common
sense. Do not operate tool when you are tired.
19. Check damaged parts
– Before further use of the tool, a guard or other
part that is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other
conditions that may afect its operation. A guard
or other part that is damaged should be properly
repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in
this instructions manual. Have defective switches
replaced by an authorized service center. Do not
use tool if switch does not turn it on and of.
20. Warning
– The use of any other accessory or attachment
other than recommended it this operating
instruction or the catalog may present a risk of
personal injury.
21. Have your tool repared by an expert
– This electric appliance is in accordance with the
relevant safety rules repairing of electric
appliances may be carried out only by experts
otherwise it may cause considerable danger for
the user.
22. Connect the dust extraction device
Wherever there are facilities for itting a dust
extraction system, make sure it is connected and
used.
23. Noise level
The noise level of this power tool is measured
according to EN 50144-1. Noise level at work
area can eceed 85 dB (A). In that case operators
should protect themselves against damage to
hearing.

Special safety instructions

. Check that the speed shown on the grinding