Service And Maintenance; Technical Data - Matrix MT 220-1 Originalbetriebsanleitung

Working with the multitool
Switching ON/OFF
Push the ON/OFF switch (2) forwards (position I)
to switch on the machine.
Push the ON/OFF switch (2) backwards (position
O) to switch o the machine.
Function principle
The tool oscillates up to 22,000 times per minute
around the drive axis due to the oscillating drive.
This helps the tool to penetrate the material
without requiring any great force and allows it to
cut cleanly evening constricted areas.
Sawing
Before starting work check that the tool is free of
foreign bodies such as nails, screws, stones, etc.
Remove them before starting work.
Only use undamaged tools.
Blunt, bent or broken tools may cause serious
inquiries.
Only make submersed cuts into soft materials
such as wood, plasterboard and the like. Not for
nails, screws, non-ferrous metals and tiles.
Observe the statutory regulations and the instruc-
tions supplied by the manufacturer for sawing
lightweight building materials.
Cutting
Only cut soft tiles and stone materials. Do not cut
hard materials such as ceramics and granite. Not
for nails, screws, non-ferrous metals and tiles.
Grinding/Sanding
Only use perfect grinding/sanding sheets.
Ensure that you apply even pressure and rotate
the machine around the working area.
The quality of the nish and the amount of mate-
rial you remove essentially depend on the particle
size of the grinding/sanding sheet and the oscilla-
ting intensity.
Excessive working pressure will result in heavy
wear on the machine and grinding/sanding
sheets and not to better results.
Grinding/Sanding sheets which have been used
on metal must not be used on wood afterwards.
Particle Material
size
Coarse All wooden
40 materials
Particle and
construction
boards
Metal, paint
and lacquer
Filler
Medium All wooden
80, 100, 120 materials
Particle and
construction
boards
Metal, paint
and lacquer
Filler
Fine All wooden
180 to 400 materials
Particle and
construction
boards
Metal, paint
and lacquer
Filler

Service and Maintenance

Pull the plug before carrying out any work on the
machine.
Use a damp cloth to clean the plastic parts.
Do not use any cleaning products, solvents or
sharp objects.
Clear the ventilation openings and moving parts
from dust with a soft brush or paintbrush at regu-
lar intervals.

Technical data

Mains voltage:
Mains frequency:
Power rating:
Idling speed:
Protection class II
Application
Coarse grinding/
sanding (initial
grinding/san-
ding)
Derusting,
areas
Remove old
coatings, etc.
Fine grinding/
sanding
Removal of
slight une-
venness, paint
spots, etc.
treatment be-
fore painting
Polishing
230 V ~
50 Hz
220 W
15000-20000 rpm
11