Personal Safety; Special Safety Instructions - Matrix EJS 610-60 Evolution Gebrauchsanleitung

•
Avoid physical contact with earthed parts, for
example pipes, radiators, stoves, refrigerators,
etc. to prevent receiving an electric shock.
•
Never carry the machine by its cable. Only pull
the cable out of the socket using the plug. Always
protect the cable from oil, heat and sharp
edges. Damaged cables can cause an electric
shock.
•
Before starting work, check the machine and
the mains cable for signs of damage.
•
When you connect the mains plug, ensure that
the main switch is not locked in its on position.
•
For outdoor use, use only extension cables that
have been specifically approved for this purpo-
se.
•
If you use a cable drum, extend the whole cable
to prevent the cable from overheating. Min. wire
cross-section 1.5 mm².
•
For working outdoors the socket must be fitted
with a residual current-operated circuit-breaker
(RCCB).
•
Pull the plug when the machine is not in use or
are making adjustments.
•
The cable should always be guided to the rear
away from the tool.

PERSONAL SAFETY

•
Do not wear loose-fitting clothing or jewellery.
•
Ensure that you have a safe place to stand and
that you wear non-slip shoes.
•
Wear a hairnet if you have long hair.
•
Loose-fitting clothing, jewellery and long hair
may become caught in moving parts.
•
Always wear safety goggles. Following this
instruction will reduce the risk of serious inju-
ries.
•
Always wear a face or dust protection mask.
Following this instruction will reduce the risk of
serious injuries.
•
Always wear ear protection. Following this
instruction will reduce the risk of serious inju-
ries.
•
Do not distract anybody working on the machine.
8
•
You may cause them to lose control of the tool.
•
Do not use the machine if its ON/OFF switch
is defective. An electric tool that cannot be
switched on or off is dangerous and must be
repaired.
•
Always switch on the machine before making
contact with the material.
•
Remove wrenches and setting tools before you
switch on the machine.
•
Do not overload the machine. If the speed falls,
reduce the load on the machine or switch it off.
Using suitable electric tools you can work more
safely and better within the specified capacity
range.
•
Secure the workpieces to prevent them turning
with the machine, for example using a clamp or
a vice. Do not machine any workpieces that are
too small to secure. If you hold the workpiece
with your hand, you will not be able to operate
the tool safely.
•
Keep electric tools out of the reach of children.
CAREFUL HANDLING AND USE OF ELECTRIC
TOOLS
•
Keep the tools clean and functional to enable
you to work better and more safely with them.
•
Use only accessories that have been recommen-
ded by the manufacturer.
•
Never cut, drill or saw into concealed areas
which may contain electric cables, gas or water
pipes. Use suitable detection equipment to loca-
te these cables and pipes.
•
Do not machine materials that contain asbestos.
•
Do not cut workpieces which are thicker than
the maximum cutting depth of the cutting disc.
•
Conduct an operating test of at least 30 seconds
without loading the machine.
•
Always switch off the machine and allow it to
reach a standstill before you put it down.

6. Special safety instructions

•
Never cut, drill, or saw in concealed areas where
there may be electric, gas, or water lines. Use a
suitable detector to find such lines.