Powerfix Z31280 Bedienungsanleitung Seite 6

Assembly
Note: You need a 5mm hexagon key (provided),
two open-ended spanners (10 mm & 14 mm) and a
slot screwdriver (1.2 x 8.0 mm) for assembly and
adjustment.
Connect the pillar to the base plate
7
Then fix the slider on the pillar (see Fig. A).
9
Mount the lever arm onto the slider (see Fig. B).
2
Tighten the screws and nuts as tight as possible.
Mount the machine vice
plate. To do this connect the screws with the
guide slots in the base plate through the two
4
long slots (see Fig. C).
14
Note: The machine vice can be positioned
exactly by moving the guide slots and long slots.
Mounting the work-piece
Hold the quick-release button
pull the locking device
15
goes (see Fig. D).
Place the work-piece into the machine vice
Press the quick-release button and push the
locking device with the clamping jaw
against the work-piece.
Fix the work-piece with a right turn (see Fig. E).
Clamping in and
adjusting the drill
Fit the drill with its clamping collar into the drill
holding fixture and tighten securely (see Fig. F).
3
Insert a suitable drill bit into the chuck.
Unscrew bolt (see Fig. G).
12
Move the slider with the clamped in drill on
9
the pillar , until the drill nearly touches the
7
work-piece.
Retighten screw securely.
6 GB/IE
.
6
onto the base
13
pressed and
16
back as far as it
.
13
17
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
Adjusting the drill depth
Loosen the block and slide it up to the
8
slider (see Fig. H).
9
Loosen the locking screw
10
left (see Fig. H).
Make sure that the bolt will be released do-
1
ing this and slides down to the lowest position.
Move the lever arm down and read off the
2
desired drill depth on the drill gauge with indi-
cator .
11
Fix the locking screw and block
10
right turn (see Fig. I).
Adjusting the work piece
Loosen the fixing screws of the machine vice
Adjust the machine vice with the work piece by
sliding it into position.
Mark the exact position and punch a drilling
point on the work-piece. Retighten the machine
vice (see Fig. J).
Storage and care
Store the hexagon key in the fixture on the slider.
Store the product in a dry place, out of the
reach of children.
Clean the product with a damp cloth.
Lightly grease the moving parts, rub the plain
metal parts with an oily cloth to protect them
from rust.
Disposal
The packaging is made from environ-
mentally friendly materials, which may
be disposed through your local recy-
cling facilities.
by turning it to the
with a
8
.
13