Werbung
1.
Eléments de commande de la face avant
1.1 Touche "Power"
Cette touche permet d'allumer ou d'éteindre le boîtier de commande.
1.2 Touches de réglage du volume +/-
pour augmenter ou baisser le volume
1.3 Touche "Mute"
permet d'activer ou de désactiver le réglage silencieux
1.4 Touche "Mode"
La touche "Mode" permet de permuter entre les différents modes audio (par ex.
Dolby Digital, Dolby Pro Logic et stéréo), en fonction du signal d'entrée.
1.5 Touche d'entrée "Input"
Permutation entre les entrées audio (Line, optique ou coaxial)
2.
Sorties haut-parleurs
2.1 FL/FR
Abréviation pour "Front Left" et "Front Right", haut-parleur avant gauche et
avant droite
2.2 RL/RR
Abréviation pour "Rear Left" et "Rear Right", haut-parleur arrière gauche et arriè-
re droite
2.3 SUB
Prise femelle pour raccorder le subwoofer
2.4 CEN
Prise pour raccorder le haut-parleur central
3.
Entrée A (entrée analogique)
3.1 Entrée Line via prise de jack stéréo de 3,5 mm
3.2 Entrée Line via deux douilles cinch
4.
Entrée B (entrée numérique)
4.1 Entrée optique
4.2 Entrée coaxiale (SPDIF)
5.
Prise femelle pour raccorder un bloc d'alimentation externe
5.1 Douille d'alimentation
Raccordez cette douille à la tension du secteur par l'intermédiaire du bloc d'ali-
mentation livré.
36
Do not stick pointed objects (e.g. ball pen, pin and knitting nee-
dles, paper clips etc.) into the ventilation slits and openings of the
speakers. This may cause a lethal electric shock and destroy the
speakers and the connected computer!
When setting up the PC speaker system make sure not to bend or jam the power
cord or other connecting cables.
11. Maintenance and Cleaning
Check the technical safety of the product in regular intervals e.g. for damages of the
housing or power cord.
If you assume that safe operation is no longer possible, put the device out of service
and protect it against unintentional operation. Disconnect the power pack from the
mains voltage, pull the mains cord!
Save operation is no longer given if the following factors apply:
- the device shows visible damage,
- the device no longer works and
- after long storage under unfavourable conditions or
- after heavy transport stress.
Before cleaning the device or performing maintenance work, you must observe
the following safety notes:
The inside of the device contains no user-serviceable parts.
When opening covers or removing parts you might expose voltage-
conducting parts.
Before cleaning, maintenance or repairs the device must be discon-
nected from all voltage sources, pull the mains cord! It is not sufficient
to switch the device off via the power switch!
Capacitors in the device may still be energised although the device
was disconnected from all voltage sources.
Repairs may only be performed by qualified personnel that is familiar
with the hazards involved and the relevant regulations.
29
Werbung
Kapitel
