Werbung
10. "Dolby Digital"
Cette led s'allume si le mode "Dolby Digital" est sélectionné.
11. "dts"
Cette led s'allume si le mode "dts" est sélectionné.
12.. "PRO LOGIC"
Cette led s'allume si le mode "Dolby Pro Logic" est sélectionné.
13. "ST"
Cette led s'allume si le mode stéréo est utilisé.
7. La télécommande
1.
"Stereo": Sélection du mode stéréo (uniquement possible si un signal Line est
arrivé)
2.. "Pro Logic": Sélection du mode Pro Logic (uniquement possible si un signal
Line est arrivé)
3.
"5.1 Ch": Sélection du mode 5.1 (uniquement possible si un signal 5.1 est arrivé)
4.
"Optical": Sélection de l'entrée optique pour signaux numériques
5.
"Line": Sélection de l'entrée Line
6.
"S_Delay": Retard du signal audio sur les caissons de graves arrières (RR/RL).
Le retard peut être réglé sur 0ms, 5ms, 10ms ou 15 ms (réglage par défaut:
0ms).
38
The above connection scheme shows the wiring options of all components.
The speakers and the terminals on the backside of the control unit are labelled
accordingly (FL, FR, RL, RR, CEN, SUB).
Instead of the SPDIF terminal you can also use the optical terminal if available.
You can connect normal audio appliances (LINE-IN) to the stereo-audio input.
9. Connection
If you do not have expert knowledge on the connection, you
should have the installation made by a QUALIFIED person or an
appropriate specialist workshop!
Improper connection may damage the PC speaker system and the
appliances connected to it.
• Switch off the PC speaker system and all connected appliances.
• Connect the subwoofer and the five satellite speakers to the control unit. The sub-
woofer, the satellite speakers and the corresponding connections on the backside
of the control unit are labelled accordingly, assemble the speaker system correct-
ly, see also the illustration in Section 8.
• Connect the control unit e.g., to the Line output of your sound card via the analog
cable (1*3.5-mm stereo jack connector to 2*cinch connector). If your audio appli-
ance (e.g. DVD player) features a digital output, connect it to the corresponding
input of the control unit via the digital cable (1*cinch connector to 1*cinch connec-
tor).
Please observe that you may only connect a low-level signal to the
Line input of the control unit.
If your sound card features an amplifier (read the manual of your sound
card!), it must be turned off as otherwise the control unit may be
destroyed by an input signal that is too high! Use for example only the
"LINE-OUT" connection of your sound card and not the "SPK" con-
nection.
When selecting the optical or the SPDIF connection make sure to con-
nect it to the OUTPUT of your audio appliance (e.g., a Hifi-CD recorder
has normally a digital input and a digital output).
• Connect the control unit to the mains voltage via the supplied power pack.
• Switch on all appliances
27
Werbung
Kapitel
