Camera-Modul (Video- And Photos); Led-Positionlights - Carson X4 Betriebsanleitung

Camera-modul (Video- and Photos)

Camera
Status LED
SD-Card Slot
1. Insert the SD card into the SD card slot and push in so that it locks
into the slot. To remove, push the SD card again, so that it slips out
again.
2. If the status LED at the bottom of the model lights, the camera
module is ready to recording. Is there no memory card in the model,
the LED flashes.
Make Photos:
Press the Photo trigger-button on the transmitter, the camera make
a single picture (photo). The status LED briefly lights up red and the
position-led's flashs 2x and confirm.

LED-Positionlights

You can switch on/off the LED-position lights via the LIGHT-
button. If the lights are deactivated, you can safe power for
longer flight time.
When you fly in twilight, you can see the model better with
positionlights.
28 CARSON X4 Quadcopter SPY sport GHz 100% RTF 500507082
SD-Card
Video recording:
Press the video-recording button on the transmitter to start recor-
ding a video clip. The status LED begins to light red and the position
Led's flashs 3x and confirm the start of the video recording. To stop
the recording, push the videorecording button again. The Red status
LED turn off and the position Led's flash again 3x.
Reading the SD card:
Turn off the model and remove the micro SD memory card. Now you
can watch or edit the captured images and videos on your PC.
Phototrigger
Videorecording
Start/Stopp
LED´s ON/OFF