Thermal Cut-Out; Frost Protection; Cleaning - Silvercrest SKD 2300 A1 Bedienungsanleitung

RP100058 Konvektor LB6 Seite 10 Mittwoch, 30. April 2014 4:42 16

6.5 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 9 to "0" to
switch off the appliance.
2. Check whether the air inlet 6 or outlet 4
is obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
2. Remove any remaining dirt with a soft
brush.
10

6.6 Frost protection

To prevent the temperature in a room falling
below 0 °C (32 °F), proceed as follows:
1. Press the button for selecting heating
25
level
protection" symbol 13 appears in
display 5.
As soon as the temperature in the immediate
vicinity of the appliance drops significantly
below 7 °C
automatically switches on.
As soon as the temperature rises to above
9 °C (48 °F), the heating switches off and
display 5 shows room temperature again.
2. To switch off frost protection, press the
button for selecting heating level 25
repeatedly
symbol 13 in display 5 disappears.

7. Cleaning

3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.
repeatedly until "Frost
(44 °F), the heating
until "Frost protection"