Introduction; Warranty; Manufacturer's Details; Copyright - BE QUIET! Silent Loop 129mm Handbuch

1.

INTRODUCTION

We are delighted you have chosen to buy a be quiet! Silent Loop water cooler.
Please read the information here and carefully follow all the instructions prior
to installation. Should you have further questions, please contact our customer
service department. See contact information in the manufacturer's details
section.
2.

WARRANTY

∙ 3-year manufacturer's warranty for the consumer (original purchase from
authorized be quiet! dealers only)
∙ Your original receipt of purchase will be required before warranty services are
rendered. Please store it carefully.
∙ Manipulations and/or technical modifications of any kind, or damage due to
the application of mechanical force, will void your warranty.
∙ To read the warranty terms and conditions in full, see Service/Warranty
Conditions on our website at bequiet.com
Our General Terms and Conditions of Business also apply. For details please refer
online under bequiet.com.
3.

MANUFACTURER'S DETAILS

Listan GmbH & Co. KG | Biedenkamp 3a | 21509 Glinde | Germany
For support in Germany, you can call our free service hotline
Monday through Friday 09:00 – 17:30 (UTC+1)
Tel. 0049 40 736 7686 - 44 Fax 0049 40-7367686-69
Email: service@bequiet.com
Website: bequiet.com
4.

COPYRIGHT

∙ You are not allowed to reproduce, disclose, publish or store the contents of
this documentation, or excerpts of it, without the prior written consent of
Listan.
∙ be quiet! is a registered trademark of Listan GmbH & Co. KG. Other products
and company names mentioned in this documentation may be the brands or
trademarks of their respective owners.
∙ In accordance with company policy, all Listan products are subject to ongoing
4
development. Listan reserves the right to make changes and improvements to
any product described in this documentation without prior notice.
∙ Under no circumstances shall Listan be held liable for loss of data or income,
or for any specific, incidental, direct, or indirect damage, however it arises.
∙ The content of this documentation represents the status at time of writing.
Listan does not assume, whether expressed or implicit, any liability for the
correctness or completeness of the content of this documentation, including,
but not limited to the implicit guarantee of market suitability and fitness for a
particular purpose, unless applicable laws or jurisdiction specifically stipulate
such a liability.
Listan reserves the right to make changes to this documentation or to withdraw
the documentation at any time without prior announcement.
5.

TROUBLESHOOTING

Insufficient cooling performance
∙ Ensure the pump is mounted as described in the instructions. Use only the
mounting equipment supplied with the unit.
∙ Please operate the pump only with 12 volts. No voltage regulator should be
used, because this can damage the device.
∙ Have you applied too much or too little thermal paste? It is sufficient when it
thinly covers the back of the CPU.
∙ After using the pump for two years or whenever a drop in coolant is apparent,
it is advisable to top up the coolant level to maintain optimum cooling
performance. For the correct way to top up the coolant, refer to the installation
instructions.
∙ Please ensure that the airflow of the fans is not restricted, to guarantee their
maximum performance.
∙ Check that sufficient room is allocated to the radiator, so it is able to draw in
sufficient cooling air and expel the warmed air.
Produces more noise
∙ Check the coolant level regularly and if necessary top it up. The right way to do
this is described in the installation instructions. When the coolant level is too
low, it leads to more noise and can damage the device.
∙ The radiator must be mounted in a suitable position in the case to prevent
vibration and turbulence in the airflow. Please also note any advice given by