Pairing - Silvercrest SBTH 2.1 A1 Bedienungsanleitung

SilverCrest SBTH 2.1 A1

Pairing

Switch off the headphones. Switch on the headphones with the switch (5). If the LED
(3) lights up blue, press the
mode. The LED (3) then alternates between flashing orange and blue. The
headphones are then in search mode for approx. 3 minutes. During this time, you
can connect a compatible device, for example, a smartphone, to the headphones
via the Bluetooth
and let it search for Bluetooth
instructions of your mobile phone. Select the device "SBTH 2.1 A1" from the list of
devices which are found and establish the connection. The name of the headphones
"SBTH 2.1 A1" now appears in the list of devices connected to your mobile phone.
When there is an established connection, the LED (3) flashes blue once briefly
about every 10 seconds. As soon as the mobile phone is switched off or is out of
range, the headphones switch to standby mode (not connected) and the LED
flashes blue twice briefly every 5 seconds.
If you want to connect another device to the headphones, you must repeat the
pairing as described previously.
Only one device can be connected at a time to the headphones. As soon as the
previously connected device comes within range of the headphones, the connection
to this device is established automatically. You may need to confirm the connection
on your mobile phone or playback device. The LED (3) flashes orange twice, then
blue once followed by blue once every 10 seconds.
14 - English
multifunction button (2) briefly to start the pairing
®
function. Activate the Bluetooth
®
devices nearby. For further details, please read the
The pairing process can take up to 30 seconds depending on the
mobile phone or playback device which is used.
If you are asked for a PIN during the pairing process, enter
"0000".
Please note that both operating modes (wired and wireless)
cannot be used at the same time.
®
function of your mobile phone