Switching On/Off The Surveillance Camera; Turn On/Off Keylock - Conrad Electronic 75 15 54 Bedienungsanleitung

7.1 Switching on/off the
surveillance camera
Turn on the surveillance camera by holding down the "ON/OFF" button (2) for 3 sec-
onds. The "POWER" status LED (14) lights up blue until the surveillance camera is
completely initialised. Then it goes out again.
A single beep indicates the beginning of the initialisation. Two beeps indicate com-
pletion of the initialisation.
The surveillance camera is now ready for operation.
Bear in mind that the surveillance camera shuts down automa-
tically after about 60 seconds if no button is pressed and no
recording takes place.
7.2 Aligning the camera using the
"LASER" (10)
Press the "LASER" button (6) to activate the "LASER" (10). Align the camera to the
desired position.

7.3 Turn on/off keylock

The keylock slide switch allows you to activate or deactivate the keylock. Symbols
on the slide switch illustrate the switch position.
24