Conrad Electronic 75 09 00 Bedienungsanleitung Seite 23

Fault Possible cause
No picture • Camera is not switched on.
• The camera is not supplied with current The
operating indicator LED does not light up,
the plug-in power unit is possibly not
plugged in.
• Batteries empty?
No sound • The camera only records images without
sound.
Flickering image. • Strong spot or floodlight within the detec-
tion range of the camera.
Picture is • Surveillance monitor is not set correctly
Surveillance (image width).
monitor too narrow
the monitor.
The image • The image format was set wrong on the
runs through. camera. Switch (2) for „NTSC" and „PAL".
Set this to PAL in Europe.
• The surveillance monitor is not set correctly
(vertical hold control).
Bad, • The light is not sufficient for a
dark image. good recording quality.
The search func- • The time searched is not available.
tion shows a
different time
than entered.
Repairs other than those just described should only be
performed by an authorised electrician.
40
The images can be recorded in the device continuously or only upon
motion in the image. This lets you easily set up a „long-time
recorder".
The images are recorded with date and time. This enables exact
image evaluation later on.
The on-screen menu eases operation of the device.
The memory can be recorded to the end or consecutively. When the
image memory is full, the continuous memory method overwrites
the images recorded first.
Please keep in mind that you will render yourself liable to prosecu-
tion, if you keep persons under observation and record them with-
out their knowledge and approval with this camera.
The surveillance camera is only licensed for connection to the sup-
plied plug-in power unit.
You can also operate the camera independent of the mains supply
with 4 batteries or accumulators (type AA).
The surveillance camera and the power pack are not waterproof and
therefore only suited for use in dry indoor rooms.
The surveillance camera is not suitable for industrial use.
Any use other than that described above could lead to damage to
this product and involves the risk of short-circuits, fire, electric
shock, etc.
No part of the product may be modified or altered!
The safety instructions should be followed at all times!
25