PRO Intellect Technology PRO MAC Gebrauchsanweisung Seite 29

Code
Chain notes Banknotes have passed through
Check again without being properly separated
The device has detected a
Double banknote with a different density
notes Check than expected, indicating possible
again counterfeit or two banknotes are
stuck together
Suspect UV The banknote has exhibited
Check again suspicious UV properties
Suspect
Banknote with different width/length
width/length
detected
Check again
Half note Improper passing of banknote or
Check again passing of half banknote
Jam Check
Jam in the hopper
again
Tilted
Tilt of notes
Check again
Reason
1. Remove banknotes from the stacker and repeat
the counting procedure
2. Adjust the slot, see Table 9
1. Remove banknotes from the stacker and repeat
the counting procedure
2. Adjust the slot, see Table 9
3. Set a lower thickness sensitivity level, see p.8.2
1. Remove the banknotes from the stacker and take
away the suspicious banknote (lying on the top).
Repeat the counting procedure
2. Use additional verification methods for the
suspicious banknote, for example, viewing UV or IR
detectors
3. Set a lower UV sensitivity level, see p 8.1
1. Remove the suspicious banknote (lying on the
top). Check the banknote, and see whether it has
different denomination or there is a different width or
length from the other counted banknotes
2. If the error occurs on the banknote, which has the
same denomination with the other counted
banknotes, increase the Width sensitivity level by 1
value, see p.8.3
Remove the suspicious banknote (lying on the top)
and repeat the counting procedure
Remove the banknotes from the hopper and repeat
the counting procedure
1. Remove banknotes from the stacker and repeat
the counting procedure
2. Adjust the slot, see Table 9
Solution
29