Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Attention! This device is intended for work from the power supply 220V/ 50Hz.
Power supplies socket should be with ground connection.
It is forbidden to use a wire and the power supplies socket without ground
connection. For work with voltage ~110В / 60 Hz open the top cover of the
counter pic. 1 pos.9 and make the switch in position 110 V.
Before using the counter it's necessary to read attentively this instruction and
observe requirements that stated in it.
The operator should keep this instruction and it must be in an available place.
• Do not install the counter in following places:
- On an inclined plane
- In a crude, dusty places
- Where the equipment is exposed to vibrations
- Where the counter is exposed to direct sun rays or direct influence of lighting
devices
• Don't use the counter with damp hands.
• During the operating time do not touch the moving parts of the counter
• Take measures against hit in the counter of liquid and extraneous subjects, writ-
ing paper clips, crampons, insects.
• Take measures against casual falling of the counter
• When using is over, check up, that there are no remaining banknotes in Hopper
and Stacker and in transport system.
• From time to time do the cleaning of device and make a technical service for keep-
ing on the technical settings, which were installed in the service center.
• Do not take to pieces and do not update the counter. It can make device out of
order or can lead to the health damage.
• Technical service, cleaning, preventive measures should be made only by the pro-
fessional of the certificated service center.
• Before the counter's switching on during the winter season it's necessary to keep
device at room temperature not less than 6 hours unpacked (or in packing not less
than 12 hours).
Remember, the manufacturer doesn't take the responsibility for possible conse-
quences in case of misuse.
Safety precautions and maintenance rules
19
Werbung
Inhaltsverzeichnis
