Clearing A Jammed Pouch; Other Problems; Maintenance And Care - LEITZ ILAM EASY A3 Gebrauchsanweisung

A
B

Clearing a jammed pouch

Jamming can occur when laminating unsuitable materials or using
pouches not recommended by Leitz.
CAUTION: To prevent any damages to the laminator, the pouch must
be removed before switching off the unit. To accomplish this, proceed
as follows:
– Press the Release lever down and pull out the pouch immedia-
tely (see figure on the left).
– Clean the rollers after any pouch jam as described in section

"Maintenance and care".

Other problems

•
Blisters or wrinkles on the print:Blisters or wrinkles on the
print:
Too much heat. If the PHOTO button lights, press it to disable the
PHOTO setting.
•
White or cloudy patches:
Pouch and/or laminated item too thick. Check whether suitable
pouches/materials have been used (see specifications).
•
Patches in margin:
– Document too thick to be laminated.
– Pouch too thick. Check whether correct pouch thickness has
been used (see specifications).
Maintenance and care
In order to remove superfluous adhesive from inside the device,
clean the rollers regularly as described here:
•
Switch on the laminator ( ). Wait until the button lights green.
•
Press the PHOTO button so that it lights.
•
Fold a sheet of unused copying paper once in the middle. Insert
the supplied Laminator Cleaning Sheet into the folded paper (see
figure A).
•
Insert the paper with the folded side first into the input tray 3–5
times (see figure B).
To clean the housing:
•
Pull out mains plug and wait for the device to cool down.
•
Wipe the exterior with a soft, damp cloth and a dishwashing deter-
gent.
7
