Cleaning The Brush Suction Nozzle And Suction Passage; Replacing The Battery - Blaupunkt XEASY Benutzerhandbuch

7.3

Cleaning the brush suction nozzle and suction passage

1. Make sure the power switch is off.
2. Take out and disassemble the roller brush kit and clean it with a soft
cleaning cloth or tool. The roller brush can be washed with water.
3. Clean the suction passage and the dust sensor with a soft cleaning
cloth or tool.
CAUTION!
1
Avoid the sensors getting wet. This could damage the robot permanently.
54
7.4

Replacing the battery

You can order a new battery in the Blaupunkt Robotics online shop.
To replace the battery, do the following:
1. Remove the screws on the battery cover (see Figure 1; Pos. 7) with a
screw driver.
2. Remove the battery cover.
3. Grasp the insulating tape at two sides of the battery and lift the battery.
4. Unplug the wire connector that links the battery and the robot.
For extending the battery life, we recommend the following:
•
If the robot is not to be used for an extended period of time, fully charge
the battery before use, turn the power off, remove the battery and store
it in a cool, dry place.
•
If the robot is not to be used for more than three months, charge the
robot for 12 hours, turn the power off, remove the battery and store it in
a cool, dry place.