Waeco PerfectView M71L Montage- Und Bedienungsanleitung Seite 27

PerfectView M71L
Observe the following instructions when laying the connection cable:
I Note
If possible, use original ducts for laying the cables, or other suitable options,
such as ventilation grilles. If there are no existing openings, you must drill a
hole with diameter of 20 mm. Check beforehand that there is sufficient
space on the other side for the drill head to come out (fig. 2, page 4).
I Note
Cables and connections that are not properly installed will cause malfunc-
tions or damage to components. Correct installation of cables and connec-
tions ensures lasting and trouble-free operation of the retrofitted
components.
To prevent damage to the cables, when laying them ensure that there is suffi-
cient distance to hot vehicle components (lights, heaters, ventilators etc.).
Wrap insulating tape around every connection on the cable (even inside the ve-
hicle).
When laying the cables, make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection (fig. 3,
page 4).
Connecting the monitor as a reversing video system (fig. b, page 7)
➤
Lay the monitor cable on the dashboard.
➤
Insert the plug of the monitor cable (2) into the socket (4) of the connection cable
(3).
e
Caution!
Make sure the polarity is correct when connecting to a voltage source.
➤
Connect the red and black cables of the connection cables to a suitable voltage
source:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤
If the monitor is to be activated when reverse gear is selected, connect the green
cable (9) to the positive cable of the reversing light.
I Note
If a voltage is present at the green cable (9), video input 2 (AV2) is automat-
ically activated.
Mounting the LCD monitor
27