Installing The Monitor - Waeco PerfectView M71L Montage- Und Bedienungsanleitung

PerfectView M71L
To make and test the electrical connection, the following tools are required:
Diode test lamp (1) or voltmeter (2)
Insulating tape (10)
Heat shrinking sleeve
Hot air blower (11)
Crimping tool (12)
Soldering iron, if required (13)
Solder, if required (14)
Cable bushing sleeves, if necessary
To fasten the cables, you may require additional cable binders.
6.2

Installing the monitor

a Warning
Select the location of the monitor so that it cannot injure anybody in
the vehicle under any circumstances (e.g. sudden braking, road traffic ac-
cidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the monitor
(fig. 6, page 4 and fig. 7, page 4).
Never install the monitor in areas where your head may impact or in the area that
would be filled by an expanding airbag. This could cause injury if the airbag opens.
The monitor may not impair your vision when driving (fig. 8, page 5).
The installation location should be flat.
Check that there is sufficient room underneath the installation location to attach
the washers and nuts.
Check beforehand that there is sufficient room for the drill head to come out on
the other side (fig. 2, page 4).
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
Ensure that you can lay the connection cables to the monitor.
To perform the installation, proceed as follows (fig. a, page 6):
➤
Slide the monitor (1) onto the mounting plate of the monitor bracket (2) and
secure it on the monitor bracket with the knurled screw (3).
➤
Position the monitor and the attached monitor bracket for testing.
➤
Mark the outlines of the corners of the monitor bracket (2) on the dashboard.
➤
Unscrew the monitor from the monitor holder.
Mounting the LCD monitor
25